Cleaning Instructions - Palram Roma Montageanleitung

IMPORTANT
Please read these instructions carefully before you start to assemble this product.
Please carry
out the
steps
in
the order
set
out
in
these instructions.
Keep
these instructions
in
a
safe place
for future
reference.
»
Care &
Safety Advice
Please
follow the instructions
as
listed
in
this manual.
Sort the parts and check against the contents
list.
For safety purposes we
strongly recommend the product to
be assembled
by at least
two people.
Some parts have metal edges. Please be careful when
handling components.
Always wear gloves, shoes and safety goggles during assembly.
Do
not attempt to assemble the Gazebo
in
windy
or
wet conditions.
Dispose
of
all
plastic bags safely
-
keep them away from children's reach.
Keep
children away from the assembly
area.
Do
not attempt to assemble the Gazebo if
you are tired, have taken drugs,
medications or alcohol, or if you are prone to dizzy spells.
When using
a
stepladder
or
power tools,
make sure
that
you are
following
the manufacturer's safety advice.
Do
not climb
or stand on
the
roof.
Heavy articles should
not
be leaned against the poles.
Keep
roof and gutters clear of snow,
dirt
& leaves.
Heavy snow load on roof
can
damage the Gazebo making
it unsafe
to
stand below or nearby.
This
product
was
designed and produced for
it's
aimed purpose only.
If color was scratched during assembly it
can be
fixed with the following tint:
Grey
-
RAL
7012
»
Cleaning Instructions
In
order to clean the Gazebo,
use
a
mild detergent solution and rinse with
cold clean water.
Do
not
use acetone, abrasive cleaners, or
other
special
detergents to
clean
the panels.
»Tools
&
Equipment
T001 (Supplied)
»
During Assembly
During assembly use
a
soft surface below the parts to avoid scratches and
damages.
When encountering the information
icon, please refer
to the
relevant assembly step for additional comments and assistance.
Step 3: It
is
recommended to
use
a
cardboard or other soft material under the
lowered corner
in
order to avoid
scratches and peeling
of
paint.
Step 10:
Optional!
Threading
an
electrical cable (for
a
fan or lamp
etc.)
is
possible
through the
roof
& legs
profiles. There
are
2
options through the leg; one of them requires
a
special drill bit.
Step 15: Note that the triangle's both sides are equal
as
shown
in
Diagram
b.
Insert the screw into the hole
in
Profile 8200 without
pressing
the
panel.
Step 23:
Optional!
The
gazebo comes equipped with
a
kit of
75
hooks Part 7829
(can be used
for
hanging curtains
/
netting
/
flowerpots
etc.) If you have purchased curtains and
or
netting kits please refer to their
assembly
instructions
at this stage.
Part 7829
is
also
supplied with those
kits.
Step 25:
Please level
the profiles' legs and adapt screws and plugs to your
specific ground type.
Attention
Screws and plugs are not supplied.
Please
tighten
all screws
when completing
assembly.
Anchoring this product to the ground
is
essential to its stability and rigidity.
It
is
required to complete this stage
in
order for your warranty to
be valid.