Collar Function And Response Table; Charge The Remote - Petsafe PDT19-16397 Gebrauchsanleitung

Collar Function and Response Table

Function
Spray collar is turned on
Spray collar is turned off
Collar is on
Spray activation
Low battery condition
Low spray warning
No refill cartridge
Spray collar is on/Cartridge is
empty (will not spray)
Turning collar on/Cartridge is
empty (will not spray)

Charge the Remote

1. Lift the rubber cover protecting the remote charging jack on the
back of the remote.
2. Connect the USB charger to the charging jack (2A).
3. Plug the USB charger into a USB port or if you have an adaptor,
plug it into a standard wall outlet.
4. The battery indicator will display when fully charged.
5. When the remote is fully charged, replace the rubber cover.
NOTE: The remote is always on, and the display will appear when any
button is pressed (2B).
Tone Symbol: Delivers a tone with non-adjustable
volume to the collar.
Vibration Symbol: Sends 1 non-adjustable level of
vibration stimulation to the collar.
Spray Symbol: Delivers 1 level of spray stimulation.
Dog 1/2: Indicates which training collar is active.
Battery Indicator: Indicates the amount of battery
remaining in the remote.
6
LED Light Response
Green LED illuminates
Red LED illuminates
Green LED light flashes once every 5 seconds
None
Red LED light flashes 3 times every 5 seconds
Yellow LED flashes once every 5 seconds
and the battery is good
Yellow LED flashes 3 times every 5 seconds
and the battery is low
Red and green LEDs alternate flashing for 5 seconds,
and the collar will turn off
Yellow LED flashes once every 5 seconds
and the battery is good
Yellow LED flashes 3 times every 5 seconds
and the battery is low
Yellow LED flashes 2 times
petsafe.com
Beep Response
Beeps low to high
Beeps high to low
None
None
None
None
4 beeps
None
2 beeps
2A
2B
Vibration/
Tone
Level Adjuster
0=Vibration
5=Spray
Spray
Dog 1
Dog 2