Acer C110-serie Benutzerhandbuch Seite 7

When you first plug in your projector, the built-in software will automatically run and ask if you want to install the application "Acer DisplayPal" for use
with the projector. Follow the onscreen instruction and install the application.
After installing the application, you will be asked to reboot your computer in order for you to be able to use the projector.
Note: It is recommended that you don't use other USB devices (External Optical drive, External HDD device, charging your mobile
phone/devices) when using the USB projector.
Note: If you have other installed USB product running, turn it off first before launching the Acer DisplayPal application.
Double-click on the Acer DisplayPal icon to launch the Acer DisplayPal application.
You will be presented with a dialog box asking you to select the number of USB plugged port.
From the application, you can choose 3 modes of display (Mirror, 1:1, Extended) and also have 4 power modes (Low, Middle, High, Turbo) to adjust
brightness of display. Recommend to plug two USB ports to adjust power modes as higher as possible.
Note: Plug 2 USB connector into you notebook and it should be on the same side. High and Turbo mode are recommended if you use
Acer notebooks.
Power Mode
Plug USB x 1 connector
Low
Middle
High
Turbo
Note: Optional USB power adapter can be purchase from the market. Plug the USB power adapter onto a wall power socket, and link
Y-USB cable with projector, notebook and USB power adapter (Master USB on notebook, Slave USB on USB power adapter).
Acer Notebook
Plug USB x 2 connectors
Ok
Ok
Not supported
Not supported
Plug USB x 1 connector
Ok Ok
Ok Not guaranteed
Ok Not supported
Ok Not supported
Non-Acer Notebook
Plug USB x 2 connectors
Ok
Ok
Not guaranteed
Not guaranteed
7