Operating Elements And Connections; Safety Notes - Monacor International JTS IN-164R /5 Bedienungsanleitung

All operating elements and connections de -
scribed can be found on the fold-out page 3.
1 Operating Elements
and Connections
1.1 Front panel
1 Receiving antennas
2 Volume control for the audio signal at the 6.3 mm
output jack (9) and at the XLR output (11)
3 Button REMOSET to set the transmitter to the
group and the channel of the receiver
ter 5.2
4 LC display
a indication RF (radio frequency) for the power
of the radio signal received
b indication AF (audio frequency) for the vol-
ume of the audio signal received
c diversity indication
the two antennas receives the more powerful
radio signal
d battery symbol to show the status of the bat-
teries in the transmitter in 4 levels
e indication LOCK when the lock function has
been activated
f indication MUTE when the muting function
has been activated
muting activated when
– no radio signal is received from the trans-
mitter or when the signal is poor
– the transmitter has been muted
(possible for transmitter IN-264TH/5 only)
g indication of the channel group
h indication of the channel
5 Button : in the setting modes to search in
descending order when selecting the group, the
channel and the identification number and to
deactivate the scan function and the lock func-
tion
6 Button SET
to activate the setting modes one after another
group (keep button pressed for a while)
→ channel → scan function → identification
number → lock function
and to confirm the settings
Note: When the lock function has been activated [indi-
cation LOCK (e)], you will only be able to activate the
setting mode for the lock function (
7 Button : in the setting modes to search in
ascending order when selecting the group, the
chap-
or to show which of
chapter 5.1.4).
channel and the identification number and to
activate the scan function and the lock function
8 On/off switch
1.2 Rear panel
9 Audio output via 6.3 mm jack (bal.) to connect a
microphone input or highly sensitive line input,
e. g. of a mixer or amplifier
10 Switch to attenuate the level (position MIC.) of
the signal at the XLR output (11) by 20 dB
11 Audio output via XLR chassis plug (bal.) to con-
nect a microphone input or highly sensitive line
input, e. g. of a mixer or amplifier
12 Squelch control to adjust the squelch threshold
13 Strain relief for the cable from the power supply
unit
14 Power supply jack to connect the power supply
unit provided
15 BNC jacks for the antennas (1) provided

2 Safety Notes

The units (receiver and power supply unit) corre-
spond to all relevant directives of the EU and are
therefore marked with
WARNING The power supply unit uses danger-
ous mains voltage. Leave servicing
to skilled personnel only. Inexpert
handling of the unit may result in
electric shock.
Please observe the following items in any case:
G
The units are suitable for indoor use only. Protect
them against dripping water and splash water,
high air humidity and heat (admissible ambient
temperature range: 0 – 40 °C).
G
Do not operate the receiver and immediately dis-
connect the power supply unit from the socket
1. if the units are visibly damaged,
2. if a defect might have occurred after a unit was
dropped or suffered a similar accident,
3. if malfunctions occur.
In any case the units must be repaired by skilled
personnel.
G
For cleaning only use a dry, soft cloth; never use
water or chemicals.
G
No guarantee claims for the units and no liability
for any resulting personal damage or material
damage will be accepted if the units are used for
other purposes than originally intended, if they
.
9