Safety Instructions; Unpacking; Operating Manual - Electric Hot Air Generator - Trotec TDS 10 Bedienungsanleitung

safety instructiOns

m Please read the instructions carefully and
thoroughly before assembling, using or
cleaning the appliance. The use of the heater
can cause severe injury due to burns, fire or
electrical discharge.
This appliance is transportable and made especial-
ly for closed quarters such as warehouses, shops
and homes, as well as for humid and damp quarters
such as construction sites. The appliance complies
with directive EN 60335-1:2002+A11, A1:04+A12,
A2:06 EN 60335-2-30:2003+A1:04+A2:07
50366:2003+A1:06 directive B.T. 2006/95/EC.
• Keep the appliance at a minimum-security dis-
tance of 0.5 metres from combustible materials.
Never use the appliance in rooms where petrol,
solvents, paints or any other substance that gives
off combustible gases, are kept, or near curtains or
other drapery.
• Keep the appliance out of the reach of children and
animals.
• Only use the appliance with a power supply that
complies with the frequency and voltage require-
ments specified on the rating plate.
• Use only three wire extension power cables with
ground wire and adequate lengths.
• Unplug the appliance from the outlet when not in
use.
• The appliance should never be positioned directly
under outlets.
• Should the appliance be left temporarily in insecure
conditions, make sure that it cannot be used and
that the plug is disconnected.
• Do not use this heating device near washbasins,
bathtubs, showers or swimming pools.
• Before beginning any kind of maintenance or re-
pairs on the appliance make sure the plug is defi-
nitely disconnected from the outlet.
• Do not cover the appliance; it could cause
over-heating.
B - 1

unpacking

• Remove all the material used to pack the appliance
for transportation.
• Remove all the objects from the box.
• If the heater looks damaged, immediately inform
the retailer where the appliance was bought.
functiOning
m read the instructions in the safety information
section thoroughly . the instructions must be
followed carefully in order for the heater to
EN
function safely .
Make sure the electric cable is not damaged in any
way. If the electric cable is damaged it must be imme-
diately replaced by the manufacturer, by the Service
Centre or by specialized personnel only. Make sure
that the electrical characteristics of the outlet corre-
spond to the requirements stated in the instruction
booklet and/or on the rating plate found on the appli-
ance. Place the appliance in an upright position.
TURNING ON THE HEATER
Plug the electric cable into the outlet. Rotate the knob
to the required position:
1 . minimum
SWITCHING OFF THE HEATER
Let the fan run for 3 minutes before turning the heater
off. Rotate the knob to the "0" position.
REGULATING THE THERMOSTAT
By rotating the knob that controls the thermostat,
you can regulate the room temperature. When the
desired temperature is reached the thermostat au-
tomatically switches the resistance off but the fan
continues working.
Operating Manual – Electric Hot Air Generator
2 . medium 3 . maximum
EN