TomTom Remote LINK Logbook Bedienungsanleitung Seite 3

EN
Preparing your Remote LINK
Remote LINK starts searching for your LINK and the
Connection LED begins to flash rapidly. Searching may
take about one minute before a connection is established.
Note: To check if a connection has been established press any
key. If a connection has been established, the Connection LED
will be on. If you do not use your Remote LINK for more than
15 seconds the device will switch off.
If no connection is established, the yellow LEDs on all three
buttons will flash and after one minute, the Remote LINK will
switch off.
To establish a connection, repeat steps 1 to 4 or visit http://
business.tomtom.com/faq for alternative connection
methods.
Reset your Remote LINK
If your Remote LINK is already paired but does not work
correctly or it is paired with the wrong device, you can reset
the Remote LINK to the default factory settings.
1. Press any key to switch on the device.
2. Press any two buttons at the same time until you hear a
sound.
Your Remote LINK switches off. To pair the device with the
LINK, read and follow the instructions under "Establishing
a paired connection".
4