TomTom Remote LINK Logbook Bedienungsanleitung Seite 2

Inserting the batteries
1. Hold the sides of the Remote LINK and press the latch on
the back of the device to open the battery compartment.
2. Insert the batteries (2 x AAA/LR3) in the Remote LINK.
Make sure you insert the batteries in the correct way, as
shown inside the battery compartment.
3. Replace the battery cover.
Establishing a paired connection
The following instructions only apply if your Remote LINK has
not been connected to a TomTom LINK. Press any key to turn
on your Remote LINK and see "Understanding your Remote
LINK" to check the status of the device.
If the device is not paired with a LINK, then do the following.
1. Make sure the LINK is properly installed in the vehicle.
2. Switch on the ignition.
3. Make sure there are no other vehicles installed with a LINK
located within a distance of 30 metres.
4. Press any button on your Remote LINK to switch it on.
If the LEDs on all three buttons are flashing, then the device
is not paired and you need to continue with the next step.
5. Press any two buttons at the same time until you hear a
sound.
Preparing your Remote LINK
3
EN
Pre-
par-
ing
your
Re-
mote
LINK