General Performance; Environmental Conditions; Pick Up Laser; Before Requesting Service - Matsushita SR-8588-B Bedienungsanleitung

6.4 GENERAL PERFORMANCE

Power rating
Dimensions (W x H x D)
Weight

6.5 ENVIRONMENTAL CONDITIONS

Operating
• Temperature
• Humidity
Non-operating
• Temperature
• Humidity

6.6 PICK UP LASER

for DVD
• Type
• Wave Length
• Divergence
• Output power
for CD
• Type
• Wave Length
• Divergence
• Output power
CHAPTER 7 BEFORE REQUESTING SERVICE

7.1 TROUBLESHOOTING

(1) There are many kinds of problems caused by misuse. When a problem occurs,
check the table below which describes possible problems occurring with your
DVD-ROM drive.
(2) If the DVD-ROM drive is not operating correctly and you cannot restore operation
by following the detailed procedures in the table below, do not remove the cover of
the units or adjust further.
(3) In the case of (2) above, unplug the unit and consult with your dealer or the nearest
service station.
TROUBLE
• DVD-ROM drive does not
operate and Busy Indicator
does not light.
A-10
+5 V
+12 V
146 x 41.3 x 190 mm(exclude Front Bezel)
835 g [ typical ]
5 ~ 50 °C
5 ~ 90 %RH
(Max. wet bulb temp. is 29 °C, Non-condensation)
– 30 ~ 65 °C
5 ~ 90 %Rh
(Non-condensation)
Semiconductor laser InGaAlP / AlGaAs
650 ± 10 nm
θ = 24 ° ~ 32 ° (Typical 28 °)
0.30 mW
Semiconductor laser InGaAlP / AlGaAs
790 ± 15 nm
θ = 25 ° ~ 39 ° (Typical 32 °)
0.23 mW
CORRECTION
Confirm that the connection between the DVD-ROM
drive and the host computer is correct.
Confirm that the program is correct.
Confirm that the setting drive select switch is correct.
Confirm that the disc has been inserted label side up.
Confirm that foreign objects have not been inserted.
1.0 A
2.0 A