Werbung
LS 255
H. 5.1 Channels Input
1. Connect the system properly. When you have 5.1ch audio input connected, it will be
5.1ch audio output. Meanwhile, when you have connected AUX(2.0ch), Opt, Coa1, Coa2
input, you can optional select play in 5.1ch & 2.1ch output.
2. Press INPUT button on the remote controller to shift the status from audio input to
5.1ch channels input.
3. Adjust all output settings including VOLUME, SW, FRONT, CEN, SURR (if necessary) now
to enjoy the wonderful and tremendous Home Theater effects.
4. Please kindly note, when the signal input from AUX/optical/coaxial 1/coaxial 2, the rear
speaker also have output if you select 5.1ch mode, but without surround effects.
I. Mute
1. Press the MUTE button on the remote controller once to keep the performance silent.
2. MUTE Indicator on the front panel will then light up.
3. Press it again to resume the performance.
J. Reset
Press the RESET button on the remote controller and it will reset all settings including
Subwoofer Speaker output, Front Speaker output, Center Speaker output, Surround
Speaker output to factory default settings. Meanwhile, the main volume reverts to 30 dB,
surround channels(FL, FR, CEN, SR, SL) revert to 0dB.
1. No output
(1) Check whether the system is connected correctly.
(2) Check whether the Volume is set at minimum. Adjust it accordingly.
(3) Check whether the Audio Input is in PLAY mode.
2. No sound from front left speaker
(1) Check whether the system is connected correctly with the Front Left speaker.
(2) Check whether the Balance function is switched off. Adjust it accordingly.
(3) Check whether the system is connected correctly with the audio source.
3. No sound from front right speaker
(1) Check whether the system is connected correctly with the Front Right speaker.
(2) Check whether the Balance function is switched off. Adjust it accordingly.
(3) Check whether the system is connected correctly with the audio source.
4. No sound from center speaker
(1) Check whether the system is connected correctly with the Center speaker.
(2) Check whether the system is connected correctly with the audio source.
(3) Check whether 2.1ch is selected as audio output.
46
Werbung
