Werbung
LS 255
Operating instruction
A. Switch On/Off and pairing the product
1. Before turning on the system, please connect it according to the System Connection
Instruction.
2. Connect AC power supply with this product.
(Caution: Power source must be consistent with this product.)
3. Press on the power switch button on the Rear Panel of the main unit to power on the
system, Press it once again to power off the unit.
4. When you start to play the system, please make sure the distance between the rear
surround speaker and subwoofer should less than 15M, because of wireless transmission.
5.When you switch on the power of subwoofer and rear speaker, the rear speaker will auto
detect and pairing with subwoofer. Please check the pairing status before you play them.
B. Volume
1. Press the Volume + button on the front panel of the main unit or VOL + button on the
remote controller to increase the volume of system.
2. Press the Volume - button on the front panel of the main unit or VOL - button on the
remote controller to decrease the volume of system.
C. Subwoofer Speaker
1. Press SW + button on the remote controller to increase the volume of subwoofer.
2. Press SW - button on the remote controller to decrease the volume of subwoofer.
D. Front Speaker
1. Press FRONT + button on the remote controller to increase the volume of Front Speaker.
2. Press FRONT - button on the remote controller to decrease the volume of Front Speaker.
E. Center Speaker
1. Press CEN + button on the remote controller to increase the volume of Center Speaker.
2. Press CEN - button on the remote controller to decrease the volume of Center Speaker.
F. Surround Speaker
1. Press SURR + button on the remote controller to increase the volume of Rear Speaker.
2. Press SURR - button on the remote controller to decrease the volume of Rear Speaker.
G. Surround effects and PCM Decoder
1. Connect and place the whole system properly accord to connection instruction.
2. Select the MODE button as 5.1ch output.
3. If the input connection is from analog 5.1ch, then the system will decode as surround
effects.
4. If the input connection is from coaxial/optical/stereo with PCM signal, then the PCM
decoder will workable; you also can switch to 5.1ch output, and get surround sound
effects output.
45
Werbung
