Inhaltsverzeichnis
Werbung
MC CD 40
Getting started
Switching on the MC CD 40 for the first time
1. Connect the mains plug to a wall outlet.
2. Extend the pig tail antenna as far as it can go.
NOTE: The quality of the FM reception will be influenced by the positioning of the pigtail
aerial.
3. Press the POWER button (6) to power on the unit.
Standby mode
Press and hold the STANDBY/PLAY/PAUSE button on the
unit (3) or press the STANDBY button (14) on the remote to put the system into standby
mode. To resume normal operation press either button again.
NOTE: When you power on the unit from standby the last used mode will resume.
General operation
DSP effects
Pressing the DSP button (33) repeatedly cycles through a set of EQ presets to alter the
sound field. Choose from 1:Jazz, 2:Rock, 3:Classic, 4:Pop, 5:Live, 6:Dance & Off.
Loudness function
This function will add a rounder bass sound at low levels. Press the LOUD button (32) on
the remote to enable. Press again to disable the effect.
Mute function
Press the MUTE button (25) at any time to silence the output. Press again to resume.
Tone controls
Adjust the Bass & Treble tone controls if required.
1. Press the TONE button (34) on the remote control.
2. The first adjustment is Bass. Use the VOL+/- buttons to adjust.
3. Press the TONE button (34) again to edit the Treble. Use the VOL+/- buttons to adjust.
4. Press the TONE button once more to edit Volume. Use the VOL+/- buttons to adjust.
Switching modes
To switch between the available modes : CD, FM & AUX IN.
Press and hold the EJECT/FUNCTION button (unit) (8) to cycle through the options or
press the relevant button on the remote control from CD/FM & AUX IN.
48
Werbung
Inhaltsverzeichnis
