Inhaltsverzeichnis
Werbung
MC+50
Getting started
Switching on the MC+ 50 for the first time
1. Connect the mains plug to a wall outlet.
2. Extend the pig tail antenna as far as it can go.
NOTE: The quality of the DAB reception will be influenced by the positioning of the pigtail
aerial.
3. Press the POWER button (6) to power on the unit.
4. The radio will automatically auto tune and operate the quick scan.
Scanning... 12
During scan mode, the LCD will display a slide bar that indicates the progress of the scan,
and the amount of radio stations that have been found so far. Once the scan has finished,
the radio will select the first alphanumeric station.
Station selection
To listen to the stations that have been found use the
/
buttons (19,28) on the
remote or PREV / NEXT ( 4,7 main unit) to cycle through. Each time you press a button the
unit will skip to the next or previous stored station. Press the ENTER button (29 remote) or
PLAY/PAUSE button (3 unit) to activate the station.
Standby mode
Press and hold the STANDBY/PLAY/PAUSE button (3) on the unit or press the STANDBY
button (14) on the remote to put the system into standby mode. To resume normal
operation press either button again.
NOTE: When you power on the unit from standby the last used mode will resume.
Positioning the antenna
1. Positioning of the aerial will influence the DAB signal quality. To find the optimum
position, select the display signal strength indicator by cycling through the display
modes using the INFO button (26).
2. Once the indicator is displayed, move the aerial and observe the signal level as shown
by the bar graph. When you are happy with the positioning, perform an auto tune to
capture all of the available stations.
57
Werbung
Inhaltsverzeichnis
