Inhaltsverzeichnis
Werbung
MC CD 40
FM operation
See Switching modes to switch to FM.
Scanning for stations
Before scanning for stations it is advised to position the antenna for best reception.
Press the SEARCH button (17). The unit will perform a scan from 87.50 MHz to 108.00 MHz
and store all found stations into the channel preset locations.
Press and hold the buttons PREV or NEXT (4&7) on the unit from the current frequency to
scan the previous or next stations, but the scanned stations will not be stored.
Setting a frequency manually
If you know the frequency of a station you wish to listen to, you can manually enter the
details.
1. Press the F (FREQUENCY) button (22). You will see the below appear on the display.
2. Use the numeric buttons (21) to enter the frequency.
NOTE: you will need to enter the full 4 digit frequency for
the unit to find the station eg:- 96.6 would be 96.60.
When entered the unit will play the station found at that entered frequency. If static is
heard and you know the frequency is correct, re-position the antenna.
Fine tuning the frequency
Should you need to fine tune a frequency you can skip up or down the frequency range in
0.05 MHz increments.
1. Press the
button (28) or press TUNER+ (7) button to skip 0.05 MHz up the frequency
range.
2. Press the
button (19) or press TUNER- (4) button to skip 0.05 MHz down the
frequency range.
Saving a station to a preset channel
Should you wish to save a station to a specific preset channel follow the below steps.
1. First enter the numeric digits for the preset location from 0-60 eg:- location 1 would be
01.
2. Then press the F (FREQUENCY) button (22) to allow a frequency to be entered.
3. Use the numeric buttons (21) to enter the frequency.
4. Press the SAVE button (18) to store the entered frequency into the entered preset
location.
49
Werbung
Inhaltsverzeichnis
