General Guidelines; Replacing The Fuse; Mounting The Device - HQ Power VDL25BM Bedienungsanleitung

3.

General Guidelines

Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.

This device is designed for professional use on stage, in discos, theatres, etc. The VDL25BM should
only be used indoors with the included power adapter connected to an alternating current of max.
230 VAC, 50 Hz.

Do not shake the device. Avoid brute force when installing or operating the device.

Select a well-ventilated location where the device is protected against extreme heat (see "Technical
Specifications"), dust and moisture. Respect a minimum distance of 0.3 m between the device's light
output and any illuminated surface.

Use an appropriate safety cable to fix the device (e.g. VDLSC7 or VDLSC8).

Familiarise yourself with the functions of the device before actually using it. Do not allow operation
by unqualified people. Any damage that may occur will most probably be due to unprofessional use
of the device.

Use the original packaging if the device is to be transported.

All modifications of the device are forbidden for safety reasons.

Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, crash, etc. Using the device in an unauthorised way will void the warranty.

The installation has to be approved by an expert before the device is taken into service.
4. Features
This bubble machine produces large quantities of bubbles for that added disco effect. The best results are
obtained with bubble liquid VDLBL1 (1 l) or VDLBL5 (5 l).
5. Installation
5.1 Adding Bubble Liquid

Only fill the tank when the device is unplugged from the mains.

Use only bubble liquid without oil or grease. Any non recommended bubble liquid may damage the
bubble machine.

Fill the tank only with specially designed water-based bubble liquid, order code VDLBL5. Carefully
pour bubble liquid into the tank.
5.2

Replacing the fuse


Only replace a fuse with a fuse of the same type and rating.

Only replace a fuse when the device is unplugged from the mains.

The fuse is an internal fuse. It should be replaced by your agent or an authorized dealer.
1. Unscrew the fuse holder on the back with an appropriate screwdriver.
2. Remove the old fuse and replace it with a new one.
3. Replace the fuse holder in the housing and fasten it with the screwdriver.
5.3

Mounting the device


For overhead mounting, make sure to mount the device according to the rules. When installing the
device on a surface, place the device on a flat and stable, non-slippery surface. Also, make sure to
place all of the rubber feet on the surface.

The installation must always be secured with a secondary attachment e.g. a safety cable.

Never stand directly below the device when it is being mounted, removed or serviced. Have a
qualified technician check the device once a year and once before you bring it into service.

Install the device in a location with few passers-by that is inaccessible to unauthorised persons

Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used. Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may
result in injuries.

Before mounting make sure the installation area can hold a minimum point load of 10 times the
device's weight.

Make sure there is no flammable material within a 0.5 m radius of the device.

This appliance is to be installed so that the blades are more than 2.3 m above the floor.
V. 02 – 02/12/2014
VDL25BM
4 ©Velleman nv