Eufab 21005 Bedienungsanleitung Seite 7

RECOMMENDATION
Ensure that the Mini Air Conditioning System is stored in a dry place and protected
against damp.
CAUTION! Use in vehicles
When used in vehicles, the Mini Air Conditioning System needs to be positioned so that
it does not hinder the driver's view. The Mini Air Conditioning System must be attached
safely and tightly to avoid possible accidents (during braking etc.).
SPECIFICATION
Operating period
Dimensions
Power cons
Ampere
Length of cable
Operation
OPERATING INSTRUCTIONS
Pic. 1 Remove the protective foil from the stand support of the air conditioning
system. You can now see the magnet that is attached to the stand support.
Pic. 2 Stand support from below. The magnet is in the middle.
Pic. 3 Remove the protective foil from the metal attachment plate.
Pic. 4 Select a suitable surface in the vehicle and affix the attachment plate to a
clean and dry base (dust and grease-free)
Pic. 5 Place the air conditioning system onto the metal plate so that the raised
surface of the attachment plate lies exactly in the groove of the air
conditioning system in the stand support.
Pic. 6 Finished. The air conditioning system (magnet) is now connected to the
attachment plate.
Pic. 7 2 Velcro pads, self-adhesive.
Pic. 8 Remove the protective foils from the Velcro plates. Caution! Avoid contact
between the adhesive surfaces and dusty materials (chair cushions, shirt,
trousers etc.). This can drastically reduce the adhesive power.
Pic. 9 Affix the Velcro plate below the stand support of the air conditioning system.
Select a suitable surface in the vehicle and affix the second Velcro plate on a
clean and dry surface (dust and grease-free).
Pic. 10 Now place the air conditioning system into the Velcro plate so that both Velcro
plates lie on top of each other. Finished. The air conditioning system is
connected via the Velcro plates.
Pic. 11 To attach using the supplied belt, select a suitable place in the vehicle or on a
shelf. Wrap the belt around the casing of the Mini Air Conditioning System and
pull the belt tight. Ensure that the Mini Air Conditioning System is secure and
that the water tank and the operating elements can be accessed.
Pic. 12 Unscrew the closing cap and fill the tank with cold water.
Pic. 13 Replace the water tank into the casing and wait approx. 15 minutes until the
fins of the water absorber are saturated.
Pic. 14 Fill the 6 water cylinders with cold water.
Mini Air Conditioning System
approx. 8 hours.
19.5 x 12.5 x 14.5 cm
Level I = 4.3 Watt, Level II = 5.4 Watt
500 mA
2.5 m
12 Volt
7