Inhaltsverzeichnis
Werbung
GB Art.-No. 21005
Mini Air Conditioning System
This product has been developed with care and manufactured for permanent use.
Please familiarise yourself with these instructions carefully before using this product.
Please keep these instructions in a safe place.
1.
Lid of the fan casing
2.
Water absorber
3.
Lid of the water tank storage
vessel
4.
Water tank storage vessel
5.
Water tank
6.
Ice storage vessel, 6 units
7.
Stand support with magnet
8.
Fan
9.
Fan casing
OPERATION
This product can be operated both with the supplied 12 V cigarette lighter cable or with
a 230V adapter (500mA, 12V) for the mains supply at home. You have 3 attachment
possibilities for this device.
Metal plate with adhesive pad
The metal plate can also be affixed to surfaces that are not smooth. The magnetic
attachment part is located in the middle of this plate.
Velcro plate with adhesive pad
This variant is designed for attachment on smooth surfaces. Simply affix the adhesive
pad below the casing in the required operating position.
Belt attachment
The belt can be used to attach the unit when adhesives need to be avoided e.g. in
shelves, cars. Wrap the holding belt around the casing of the Mini Air Conditioning
System and attach to a suitable point. Ensure that the two-level switch and the water
tank filling parts remain accessible.
INSTALLATION
Remove the adhesive pad of the metal plate and attach to the required position. Place
the stand support with the magnet onto the metal plate. To ensure that the ventilation
functions adequately, the distance between the Mini Air Conditioning System and
yourself should not be more than 0.5 m.
FUNCTION
Open the lid of the water tank casing. Remove the water tank then unscrew the closing
cap and fill the tank with cold water. Replace the water tank into the casing and wait
approx. 15 minutes until the fins of the water absorber are saturated. Switch on the Mini
Air Conditioning System via the 2-level switch (I - for slow and II - for fast) to the
required speed. For an even better cooling effect, simply fill the 6 ice cylinders with
water and freeze. Replace the frozen ice cylinders into the water tank.
CLEANING
Open the casing lid and remove the water absorber. We recommend cleaning the
absorber's fins once a week. Clean the fins by brushing carefully with soapy water.
After cleaning, replace the water absorber into the casing and close the lid. You do not
need to wait until the fins have dried off before using the device.
10. Setting lever for air slits
11. Jack for electro cable
12. 2-level on/off switch
13. Metal attachment plate with self-
adhesive pad
14. Cigarette lighter cable
15. 230 Volt adapter
16. Tension belt
17. Velcro pad
6
Werbung
Inhaltsverzeichnis
