Installation - mastro PGF series Bedienungsanleitung

Product
INDUSTRIAL GAS GRILL
PLATES
1. INTRODUCTION
This manual should be carefully read and keep it for as long as the grill plate is in use
All operations such as installation, any kind of adaptations (e.i. changing the type of gas),
or any kind of repair, must be carried out by a qualified technician, who should carry out the
regulations in force.
This device should only be used for the specific end for which it was built. It should never
be subjected to other combustible materials, abrasive detergents, or any other objects that
might damage the plate.
Only adults should operate this device, and thus children should avoid touching the grill.
For hygienic and safety reasons, this device must always be kept clean.

2. INSTALLATION

When unpacking the machine, make sure that it is undamaged.
Remove all the materials used for packing as well as the plastic used to protect the
structure of the machine.
Check the label on one side of the machine and make sure that the gas indicated is the
same as the one that is going to be used. If the machine is indicated for another type of gas,
please remember that only a qualified technician may carry out the change.
Choose the place where the machine is going to be installed, bearing in mind the
following instructions:
The machine must be placed in a well ventilated location, underneath a suction fan with
suction capacity of at least 1500 m3 /h
The grill stand, as well as everything surrounding it must be made out of non-combustible
materials.
There should be a distance of at least 150 mm between the grill and walls or any other
machines.
The stand must be well leveled.
The grill must be secured with four M10 screws, with at least 15 mm of available coil,
must be put in the location where the machine in going to be installed. These screws will go
on the grill's feet. The screws must be placed in the shape of a rectangle with the following
measurements: 782mm x 322 mm for models PPGF 800 and PPGF 800 CRD, and 582 mm x
322 mm for models PPGF 600 and PPGF 600 CRD.
Make sure that the taps are turned off.
It is now possible to connect the gas hose (metallic tube), according to the regulations in
force, avoiding all kinds of pressure, any tight curves or squeezing the tube too much. The
grill must be connected to a fixed installation through a sphere type tap.
INSTRUCTIONS MANUAL
Model
PPGF 800
Versions
PPGF 600
PPGF 600 CRD
PPGF 800 CRD
1 GB