Device Elements; Flow Restrictor; Spray Head; Installing The Spray Head - Kärcher WR 10 Originalbetriebsanleitung

Device elements

1 Spray lance
2 Power nozzle
3 Screw connections
4 Temperature indicator

5 Spray head

Flow restrictor

In order to maintain a consistently high tem-
perature (above 90°C) of the water, a pow-
er nozzle must be inserted into the screw
connection of the spray head to restrict the
flow.
Note
The necessary power nozzle is matched to
the corresponding high-pressure cleaner
and must be ordered separately.
Hot water high-pres-
sure cleaner
HDS 6/14 C
HDS 6/14-4 C
HDS 7/12-4 M
HDS 7/16 C
HDS 8/17 C
HDS 8/18-4 C
HDS 8/18-4 M
HDS 9/18-4 M
HDS 10/20-4 M
HDS 12/18-4 S
HDS 13/20-4 S
HDS 1000 De
HDS 1000 Be
HDS 13/20 DeTr.1
HDS 17/20 DeTr.1
6
Order
number Power
nozzle
2.113-070.0
2.113-070.0
2.113-006.0
2.113-041.0
2.113-071.0
2.113-071.0
2.113-071.0
2.113-005.0
2.113-021.0
2.113-010.0
2.113-025.0
2.113-071.0
2.113-071.0
2.113-071.0
2.113-071.0
EN
Note: Power nozzles for hot water high-
pressure cleaners not listed here must be
requested from the service partner.
Spray head

Installing the spray head

 Push power nozzle into the screw con-
nection.
 Screw the spray head onto the spray
lance.

Operation

WARNING
Risk of burns! Do not direct the stream of
water at people or animals.
During operation, do not touch WR 10 or
reach into the stream of water.
 Set the device switch on the high-pres-
sure cleaner to max. 98 °C.
 If installed, set the Servo Control to the
max. setting.
Note
Depending on the high-pressure cleaner in
use, the heating-up time can last between
2 and 5 minutes.

Temperature display

The temperature indicator provides infor-
mation on when the required water temper-
ature has been reached.
– 2