Programming With The Easy Base Unit - Gewiss Chorus GW 10 756 Bedienungsanleitung

PROGRAMMING WITH THE EASY BASE UNIT

Programming the device through the Easy base unit (code GW 90 831).
The device to be used in the function that is to be created can be selected at choice:
• locally by causing the detector to intervene: the corresponding channel will be
highlighted in the channel list in the "Application
Edit function" menu;
• directly from the list of channels of the "Application
Edit function" menus.
Names of the functions on the Easy base unit
timer mode
The function can be created after the device has been selected.
Refer to the Easy base unit documentation for further information on the programming
procedures.
After creating the desired function, it is possible to configure the device function
parameters from the "Application
The parameters available, in relation to the function created, are listed in the following
table.
The underlined value is the default value.
Function: timer mode
Parameter: transmission period
10s
30s
45s
1m
2m
5m
Function: timer mode
Parameter: keep move. applica.
disabled
enabled
command ON with timer
(the time is set on the actuator)
Configuration parameters (Easy)
Parameters" menu.
cycle time – 10 seconds
cycle time – 30 seconds
cycle time – 45 seconds
cycle time – 1 minute
cycle time – 2 minutes
cycle time – 5 minutes
conditioned detection deactivated
conditioned detection activated
New function" or "Application
New function" or "Application
21
E
N
G
L
I
S
H