Juniper NETSCREEN-5GT Benutzerhandbuch Seite 22

Chapter 2 Configuring the Device
CLI
set interface adsl1 ip 1.1.1.1/24
set pppoe name poe1 static-ip
save
or
set interface adsl1 ip 1.1.1.1/24
set pppoa name poa1 static-ip
save
To use Domain Name System (DNS) for domain name and address resolution, the
computers in your network need to have the IP address of at least one DNS server. If the
NetScreen device receives an IP address for the ADSL interface through PPPoE or
PPPoA, it also automatically receives IP addresses for the DNS server(s). If the computers
in your network obtain their IP addresses from the DHCP server on the NetScreen device,
then the computers also obtain these DNS server address(es).
If you assign a static IP address to the ADSL interface, then the service provider must
give you the IP address(es) of the DNS server(s). You can either configure the DNS server
address on each computer in your network, or configure the DHCP server on the Trust
zone interface so that it provides the DNS server address to each computer.
To configure the DHCP server on the Trust interface to provide the DNS server address
1.1.1.152 to computers in your network:
WebUI
Network > DHCP > Edit (for the Trust interface) > DHCP Server: Enter 1.1.1.152 for
DNS1, and then click Apply.
CLI
set interface trust dhcp server option dns1 1.1.1.152
save
Annex B Mode
If you connect the Annex B model of the NetScreen-5GT ADSL device to a Deutsch
Telecom ADSL line, you must configure the physical interface on the ADSL port for
operation with this equipment. To do this:
WebUI
Network > Interfaces > Edit (for the adsl1 interface): Select DT for the Annex B Mode,
and then click Apply.
CLI
set interface adsl1 phy annex-b-mode dt
save
You do not need to configure this setting if you are using the Annex A model of the device
or if you are connecting the device to non-Deutsch Telecom equipment.
18 User's Guide