Silva ADC WIND Benutzerhandbuch Seite 33

11.6 Temperature Mode -
Wind Chill Temperature Alarm and
hold
Temperature Calibration
[mode]
Setting Sequence
TEMP 8 C
Temperature
28.3
18.2 13.2
hold
[mode]
Temperature Mode
Wind Chill Temperature
Alarm Setting
Alarm ON
Alarm OFF
W.CHILL 8 C W.CHILL
[set]
OFF ON
- - - -
18.3 8.3 18.3
hold
[reset]
[reset]
scroll the
scroll
setting by
the setting
increment
faster
of 1 step
Setting the Wind Chill Temperature Alarm
[mode]
Wind Chill
Temperature
Calibration
Alarm
Temperature
Calibration Display
TEMP
8 C
OFFSET
0.0
-10.0
18.3
8.3
flash
[mode]
Calibration Setting Display
Check 'Calibrating
the Temperature' section
below for more detail
To Select Setting Display
!
To select the setting display, press and hold
the [mode] button for about 2 seconds to
select the setting display (temperature digits
will start flashing).
The Setting Sequence
!
When the temperature digits are flashing,
press the [mode] button to select between
the Wind Chill Temperature Alarm Setting
a n d Te m p e r a t u r e C a l i b r a t i o n D i s p l a y
following the adjacent diagram. Check the
'Calibrating the Temperature' section below
8 C
for more detail on temperature calibration.
!
When the temperature digits are flashing,
press the [reset] button to scroll through to
8.3
select target wind chill temperature level
(hold down the button to scroll the setting at
a faster pace), or press the [set] button to
select the between wind chill temperature
hold
alarm ON and OFF.
[reset]
!
When the above settings finished, press and
hold the [mode] button for about 2 seconds
to exit the setting sequence.