Silva ADC WIND Benutzerhandbuch Seite 17

9.2 Race Timer Mode -
RACE TIMER
0:10.00
Stop-Counting Display
set the
target
time to
30 minute
RACE TIMER
0:30.00
Stop-Counting Display
[reset]
Note:
This diagram illustrates the
general flow among different
functional displays only, and
may NOT conform to fact in all
instances.
Using the Race Timer
RACE TIMER
beeps
STOPPED
0:00.00
stop
counting
Stop-Counting Display
29'59"
RACE TIMER
[set]
RUNNING
0:29.59
counting
Counting Display
[set]
stop
counting
RACE TIMER
STOP
0:29.59
Stop-Counting Display
To Use the Race Timer
!
Once a target time has been set, press the
[set] button once to start the countdown.
When it is running, press the [set] button
again to stop the countdown.
!
The countdown time will be displayed
continuously throughout the operation.
To Reset the Timer
!
To reset the timer to the preset target time
before the countdown reaches zero, press
the [reset] button once when the timer has
been stopped.
!
To set a new value for the target time, check
the previous 'Setting the Race Timer Mode'
section for more detail on how to set the
Racer Timer Mode.
Race Timer Alarm Sound
!
At the last 10 minutes, the Alarm will beep
once for every minute.
!
At the last 10 seconds, the Alarm will beep
once for every second.
!
At zero, the Alarm will beep for about 2
seconds.