Power Linking; Fuse Replacement; Mounting Diagram - Chauvet DJ Intimidator Hybrid 140SR V2 Schnellanleitung

AC Power
This product has an auto-ranging power supply that works with an input voltage range of 100 to 240 VAC, 50/60 Hz.
To eliminate wear and improve its lifespan, during periods of non-use completely disconnect the
product from power via breaker or by unplugging it.

Power Linking

For the maximum number of Intimidator Hybrid 140SR V2 products that you can power link at each voltage, see the User
Manual or the sticker on the product.
Warning! When power linking this product, lamp ignitions must be offset to avoid high inrush
currents. The ignition delay of the first product in a power linking chain must be set to no less
than five seconds. The ignition delay of each subsequent product in the chain must be at least
five seconds more than the previous product.

Fuse Replacement

1. Disconnect the product from power.
2. Using a flat-head screwdriver, unscrew the fuse holder and pull straight out.
3. Remove the blown fuse from the holder and replace with a fuse of the exact same type and rating.
4. Re-insert the fuse holder and reconnect power.
Mounting
Before mounting this product, read the

Mounting Diagram

Intimidator Hybrid 140SR V2 QRG Rev. 2
QUICK REFERENCE GUIDE
Safety Notes.
Mounting Clamp
(such as CLP-15 from Chauvet)
Mounting Bracket
Safety Cable
(such as CH-05 from
Chauvet)
Rubber Feet for Floor Mounting
(x4)
EN
2