Maintenance - System Sensor M200I-RF Installations- Und Bedienungsanleitung

Remote Indicator Status LEDs
RI Status LED State
Long Green pulse
Power-on initialisation
(no fault)
3 Green blinks
Fault Blink Amber every 1s.
Red/Green double-blink every 14s
Un-commissioned
(or just Green when communicating).
Green/Amber double-blink every 14s
Sync
(or just Green when communicating).
Controlled by associated device; can be
Normal
set to Red ON, periodic blink Red or OFF.
Idle (low power mode) Amber/Green double-blink every 14s
Pittway Tecnologica S.r.l. Via Caboto 19/3, 34147 TRIESTE, Italy
(For further information on commissioning and uncommissioning, see
the Radio Programming and Commissioning Manual - ref. D200-
306-00.)
LED INDICATORS AND FAULT DESCRIPTION
The remote indicator LEDs show the status of the device as follows:
Meaning
Device is un-commissioned
(factory default)
Device is commissioned
Device has an internal trouble
Device is powered and is waiting to be
programmed.
Device is powered, programmed and
trying to find/join the RF network.
RF communications is established;
device is working properly.
Commissioned RF network is in standby;
used when the gateway is powered off.

MAINTENANCE

When changing the batteries, both should be replaced.
Identifying if a Device has been Commissioned or not
Take the device and remove all the batteries. Then insert one battery
into position #1 while watching the device LED. After a few seconds
the green LED will blink. If initially the LED gives one long green
blink, the device is un-commissioned. If however the LED gives
three short green blinks, the device is commissioned.
Patents Pending
EU Declaration of Conformity
Hereby, Life Safety Distribution GmbH declares
equipment type M200I-RF
The full text of the EU DoC can be requested from:
HSFREDDoC@honeywell.com
that the radio
is in compliance with directive
2014/53/EU
I56-6235-001