To unlock the device press DOWN- and ESC-button together and hold them pressed about three sec. The
device will be unlocked:
,INPUT CONTROL MODES
The device can work with different type of input signals: DMX-512/RDM, 0/1-10V, DALI.
The input control mode can be set by placing the jumper on right position at PCB.
See page 27 till 30.
,INPUT CONTROL MODE –
The device works in DMX mode, if the jumper on the PCB is in correct state.
See page 30.
SETUP –
Access to the setup menu items
DMX –
Address (1-507) and slave address (1-20)
MANUAL –
Desired colour can be adjusted manually with the buttons
SINGLE –
Standalone programs can be selected
MASTER –
Standalone programs can be selected and the DMX signal is sent to additional devices for
synchronization.
MBN GmbH, Balthasar-Schaller-Str. 3,
,
DMX,
86316 Friedberg - Germany
www.proled.com
Bedienungsanleitung / Users manual
33