Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
，SWITCHING
ON，
When the device is connected to mains supply, the dimmer is ready for operation.
During initialization the MBNLED Logo is displayed for a short time.
After 3 seconds the display proceeds automatically. The controller is now in one of the five main modes.
DISPLAY
The display is divided in three parts:
LEFT:
data of the current mode are shown
MIDDLE:
bar graph for the outputs
RIGHT:
generic information of the device
Generic Information
Top right of display:
NO LED POWER –
OVERHEAT –
WRONG CONFIG –
FAULT –
12V/24V - CA/CC – 76.0Hz-19,5 kHz – Correct function
MBN GmbH, Balthasar-Schaller-Str. 3,
Bedienungsanleitung / Users manual
No voltage for LED units is measured
The device is above the rated maximum temperature
Internal wiring CA/CC on the power board not correct
A not specified error. Please contact the technical service
86316 Friedberg - Germany
www.proled.com
31
Werbung
Inhaltsverzeichnis
