TEN TNKCE Anweisungen Und Hinweise Für Den Installateur Seite 28

Manual release and movement: before performing this operation, take care that the release is activated only
when the leaf is stationary.
To release, rotate the handle anti-clockwise and
manually move the leaf (Figure 48)
48
Control with safety devices disabled: in the event of
a malfunction of the safety devices on the door, movement
is still possible.
• Activate the door command (by means of the remote
control, key-operated selector switch, etc.); if all is in
working order the door opens and closes normally; oth-
erwise the flashing light flashes several times and the
manoeuvre is disabled (the number of flashes depends
on the reason for which the manoeuvre is inhibited).
• In this case, press and hold the command again
within three seconds.
• After approx. 2s door movement is started in "hold-to-
run" mode, i.e. as long as the command is pressed the
door continues to move; and stops immediately on
release of the control.
In the event of safety device malfunction, arrange
for repairs to the automation immediately.
Lamp replacement: before performing this operation, disconnect the power supply from TEN.
1. Loosen the screws to open the cover as shown
in (Figure 50).
50
Satisfied? Should you wish to add a new automation system to your home, contact both your local installer and Nice
to guarantee specialist consultancy and state-of-the art products on the market, for optimal operation and maximum
compatibility of automations.
Thank you for reading this information. We wish you total satisfaction with your system. For all present and future require-
ments contact your local installer.
28
To reset, return the handle to the vertical position
by turning it clockwise, and manually move the
leaf until it engages (Figure 49)
49
Remote control battery replacement: after a certain
period of time, if you notice a deterioration in performance
of the remote control, or if it stops working completely, it
may simply be due to a flat battery (depending on the use,
the battery can last from several months to over a year).
This is indicated by the fact that the transmission indicator
does not light up, is faded, or only lights up briefly. Before
contacting the installer, change the battery with one from
another operative transmitter: if this is the cause of the
fault, simply replace the battery with one of the same type.
Caution: Batteries contain pollutant substances: never
dispose of in common waste disposal units, and observe
all local regulations for the procedures required.
2. Unscrew the lamp and replace with a new ver-
sion of 12V/10 W fitting BA15S (Figure 51) .
51