Fitting The Skimmer - Swim & Fun SNF1533 Installations- Und Bedienungsanleitung

2.3

Fitting the skimmer

To fit the skimmer, repeat the procedure to mark the skimmer hole (see below). The skimmer set
may contain either 2 x single gaskets or one double gasket. Fit the double gasket (4) around the
skimmer perimeter and the hole in the lining so that the gasket seals both the pool wall and the li-
ner. Fit single gaskets one on each side, i.e. one on the outside of the liner and one on the outside
of the pool wall.
Single gasket
A tip to help you fit single gaskets:
• Push a screw through the upper holes on the right and left of the front skimmer frame and the
gasket on the inside of the pool.
• The position of the two screw holes is now marked on the inside of the liner by the two screws
inserted in the front skimmer frame (3).
• Prick a hole in the liner to mark these two positions.
• Now fit the front frame and skimmer gasket to the inside of the pool.
NB: Both screws must be inserted from the inside and out through the pool wall.
Fit the other skimmer gasket onto the screws on the outside.
Side 4
MV-1533-09-2016 . Swim & Fun Scandinavia . info@swim-fun.dk . www.swim-fun.com
© All rights reserved Swim & Fun Scandinavia ApS 2016