Fitting; Perforations In Pool Wall; Fitting The Return Tube - Swim & Fun SNF1533 Installations- Und Bedienungsanleitung

2.

Fitting

Use a pool skimmer to clean the water surface and keep your pool looking clean and clear. The
skimmer is self-adjusting. Although the water level may vary, the skimmer always cleans a couple
of centimetres at the surface. However, the skimmer works best when the water level is at about
the centre of the skimmer mouth. At this level, the filter system operates perfectly and there is no
risk of it running dry. The skimmer basket (5)(included) must always be fitted inside the skimmer
when the filter system is on.
2.1

Perforations in pool wall

2.2

Fitting the return tube

The pool is filled with water to approximately 5 cm under the perforations for the return tube.
To seal the return tube on the outside of the pool wall, use plenty of teflon tape on the hose
coupling threads before threading it onto the return tube.
MV-1533-09-2016 . Swim & Fun Scandinavia . info@swim-fun.dk . www.swim-fun.com
© All rights reserved Swim & Fun Scandinavia ApS 2016
When vacuum-cleaning the pool floor, you
can fit a hose to the filter system via the
skimmer suction plate (6). Fit the pool hose
to the suction plate using the elbow hose
connector (7)(included).
There are perforations in the pool wall for
making holes for the skimmer and return
tube. The holes can be cut out and all une-
ven surfaces are then removed with a file.
Lastly, the edges should be treated with an
anti-corrosion agent. If this is not done, the
edge may rust.
Draw/mark the round hole in the liner and
then cut an X in the circle with a sharp knife.
Do not cut beyond the marked hole. Now fit
the return tube (11) and a gasket (12) from
the inside of the pool and out through the
pool wall. Attach the return tube to the pool
wall by firmly tightening the plastic nut (13).
Do not overly tighten the nut. odt fast. Undgå
at overspænde omløberen.
Side 3