Output Wiring, Connecting Components To The Relay Outputs - Abus FUMO50110 Installations- Und Bedienungsanleitung

Please note the following.
Circuit board label
Z1
Z2
Z3
Z4
Z5
Z6
Z7
Z8
Z9
Z10

Output wiring, connecting components to the relay outputs

You can open (NC-C) or close (NO-C) a connected circuit.
Note the contact capacity (current, voltage) of the relay.
Note
You can configure the outputs (type, name, partitions, polarity, options) in installer
mode -> outputs -> HyMo outputs
Note
Function
Alarm loop zone 1
Tamper loop zone 1
Alarm loop zone 2
Tamper loop zone 2
Alarm loop zone 3
Tamper loop zone 3
Alarm loop zone 4
Tamper loop zone 4
Alarm loop zone 5
Tamper loop zone 5
Image 8
Installation
67 | EN