YATO YT-0925 Anleitung Seite 11

PROPERTIES OF THE TOOL
The pneumatic hammer for nails is a tool powered with compressed air at a specifi c pressure. It permits to easily connect elements. A correct, reliable and safe functioning
of the tool depends upon its proper operation, therefore:
Before you commence to work with the tool, read the whole manual and keep it.
The supplier will not be held responsible for any damage and injuries caused by operation of the tool for any purpose other than intended or due to inobservance of safety
regulations and recommendations indicated in the present manual. Should the tool be used for any purpose other than intended, the guarantee will become void and the
user will loose any contractual rights.
EQUIPMENT
The hammer is equipped with a connector that permits its connection to a pneumatic system.
TECHNICAL DATA
Parameter
Catalogue number
Weight
Diameter of the compressed air connector
Internal diameter of the compressed air conduit
Type of connecting elements
Length of connecting elements
Dimensions of connecting elements
Maximum operating pressure p
s max
Recommended operating pressure
Acoustic pressure (PN-EN 12549:2001)
Acoustic power (PN-EN 12549:2001)
Vibration (PN-EN ISO 8662-7:2000)
GENERAL SAFETY CONDITIONS
WARNING! During operation of a pneumatic tool, it is recommended to always observe the basic safety regulations including those mentioned below, in order to diminish
the risk of fi re, electric shock and injury.
O R I G I N A L
Unit of measurement
[kg]
[''] / [mm]
[''] / [mm]
[mm]
[MPa]
[MPa]
[dB(A)]
[dB(A)]
[m/s 2 ]
I N S T R U C T I O N S
Value
YT-0925
0,63
1/4 / 6,3
3/8 / 10
nails
50 - 100
Drawing III
0,7
0,55 - 0,7
93,5 ± 2,5
106,5 ± 2,5
18,4 ± 1,5
11