Herunterladen Diese Seite drucken

Blaupunkt ESC808 Bedienungsanleitung Seite 10

Vorschau ausblenden Andere Handbücher für ESC808:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 13
ESC808
Charging the battery
• Make sure that the electrical outlet is dry.
• To (re)charge the battery when it is installed in the scooter, lift the charger-port cap on the
handlebar, just above the scooter-folding device.
To (re)charge a removed battery, lift the charger-port cap at the bottom of the battery.
• Plug the adapter plug into the power source (110 V ~ 240 V, 50 Hz ~ 60 Hz), make sure the green
charging lamp is lit, insert the other adapter plug into the scooter's charging socket.
• When the red LED on the power supply lights up, the battery is charging correctly, otherwise check
all cable connections.
• When the red light turns green, the battery is fully charged. Disconnect the power supply from the
power source. Long-lasting charging can shorten battery life.
• Follow the instructions for charging the battery, otherwise it will damage the battery and shorten
its service life.
• The time to charge the scooter's battery is about 2 hours. The manufacturer cannot guarantee the
same charging time and operation of the battery due to its wear.
• Ensure clean and dry conditions when charging the battery.
• Do not charge the battery when the power outlet is wet.
First run
Preparation
• Select the desired location. This place can be inside or outside, it must have an area of 10 x 10 meters
(about 100 square meters). The place should be flat, neither wet nor slippery, without obstacles,
without vehicles, children, pets or any other things that could distract your attention.
• Read this manual carefully, if you have the opportunity to do so, for advice from a person who is
more experienced in safe driving.
• Wear helmet and protectors to avoid possible injuries. Move the scooter to the center of the area
where you will be moving and familiarize yourself with the area.
Start
• Press and hold the POWER push button for 2 seconds to switch the scooter on, then select one of the
three speed modes
• Place one foot on the deck plate and with the other foot kick-start the scooter
• Place the other leg on the deck plate and ensure you keep your balance
• Press the thumb throttle with your right thumb, and do not ride too fast
• Squeeze the brake lever with your left hand to brake, and gently press the rear fender to assist the
braking
• You can get off the scooter when it is running at a low speed or after it has come to a complete stop
• To warn other users that you are nearby, use the bell fitted next to the brake lever
Charging
port
8
Battery
interface

Werbung

loading