Noise Emission; Use According To Intended Purpose - Mafell NFU 32 Betriebsanleitung Und Ersatzteilliste

Universal motor, radio and TV interference suppressed
Power input (continuous operation)

1.4

Noise emission

Noise emission values determined according to EN 60745-1:
No load
Operation
The noise measurements were recorded using the cutter included in the standard equipment.
Workpiece: Spruce 140 x 140 x 2,000 mm (5 1/2 x 5 1/2 x 78 3/4 in.)
Cutting depth: 20 mm (3/4 in.)
Without guide fence
The stated values do not take any series variance into account and are not suitable for determining the immis-
sion sound power level, since this varies depending on the operating time, the machining operation concerned
and environmental factors. The immission sound power level can consequently be determined only in the indi-
vidual instance on the premises of the machine user.
1.5 Vibration
The typical rated acceleration is 3.6 m/s
1.6 Delivery specification
Groove-cutting machine NFU 32 complete with:
1 expanding grooving cutter with reversible TCT knives
x 30 mm)
1 parallel guide fence
3 service tools
1 operating manual
1 folder «Safety instructions»
1.7

Use according to intended purpose

The MAFELL groove-cutting machine NFU 32 is
intended exclusively for cutting wood.
The dimension of the tools used must correspond to
the measurements mentioned in this operating man-
ual.
- Diameter of cutter: max. 125 mm (4 15/16 in.)
- Width of cutter: max. 30 mm (1 3/16 in.)
- Only use cutters suitable for manual feeding
Any use beyond this scope is considered as failing
to comply with the intended purpose. The manufac-
turer is not liable for any damage caused as a result
of this; the risk is borne solely by the user.
The machine is not suitable for operation in the rain
outdoors or in areas subject to explosion hazards.
Sound power level
105 dB (A)
104 dB (A)
.
2

125 x 15.4 – 26.5 x 30 mm (4 15/16 x 5/8 – 1 1/32 in.
Use according to intended purpose also includes
compliance with the operating, maintenance and
repair conditions specified by MAFELL, and adher-
ence to the safety instructions contained in the oper-
ating manual.
The groove-cutting machine NFU 32 may only be
used, set up and serviced by persons over 18 years
of age who are familiar with the machine and have
been instructed as to the dangers involved. Repair
work must be carried out by authorized MAFELL
dealers or a MAFELL customer service station.
The safety regulations applicable in the country of
use, as well as all other generally accepted rules on
safety and occupational medicine, must be
observed.
Unauthorized modifications to the machine preclude the
liability of the manufacturer for any resultant damage.
-14-
230 V~, 50 Hz
1600 W
Workplace-related
emission value
94 dB (A)
93 dB (A)