THOMSON MIC200IBT Bedienungsanleitung Seite 23

Note the following information: Only use the power supplies listed below.
Specification:
Power:
Remote control power source: 1 x CR2025 3V battery (included)
Frequency ranges:
Bluetooth Pairing name :
Remark: The maximum connection distance is around 10 meters. Please place your Bluetooth
speaker as close as possible to this device to avoid connection getting disturbed.
WARNING! Risk of hearing impairment
• Set a low volume on the playback device before connecting the headphones to the
sound source.
• Avoid excessive volume, particularly over extended periods or frequent use. Excessive
volume can result in permanent hearing impairment.
About the disks
AC100-240V~ 50/60Hz 0.3A
FM 88.8 – 108MHz
MIC200
Handling
Do not touch the underside of disks.
Hold disks by the edges to avoid leaving fingerprints on the surface.
Any dust, fingerprints or scratches may cause a malfunction.
Never affix a label or sticky tape to the disk.
Storage
Put disks back in their case after use.
Never expose disks to direct sunlight or heat sources. Never leave disks
inside a car parked in full sunlight.
Cleaning
Use a clean, soft, lint-free cloth to clean the disk, working from the centre
outwards in a straight line. Do not use solvents such as petrol, thinners,
commercially available cleaners or antistatic sprays for vinyl disks.
- EN 10 -