Bluetooth Mode; Set The Time And Alarm - THOMSON MIC200IBT Bedienungsanleitung

automatically selected when you switch the radio back on.
Tuning to an FM Station
Press the PLAY/PAUSE/SCAN button to scan up the frequency band.
Press the NEXT/PREV button to fine tune each frequency in 0.05MHz increments.
Note: If reception is still poor, try moving the radio to another location.
Storing an FM Station Preset
Your radio can store up to 20 FM radio stations in its preset memories for instant access to your
favourite stations.
1. Tune the radio to the FM radio station that you wish to preset.
2. Press and hold the PROG/REP/PRESET button for approximately 2 seconds until 'P01' is displayed.
3. Use the NEXT/PREV button to move to the preset location to which you would like to store the
radio station (1-20).
4. Press and release the PROG/REP/PRESET button to confirm.
Note: If there is already an existing FM station stored under a preset, it will be over-written when you
store the new station.
Tune to an FM Station Preset
In FM mode:
1. Press and release the PROG/REP/PRESET button.
2. Use the NEXT/PREV button to move to the preset location and station that you would like to listen
to (1-20); the radio will instantly tune to that station and begin to play.

Bluetooth Mode

You must follow several steps to connect your mobile phone:
1. Activate Bluetooth from your mobile phone (please refer to your phone's user manual)
2. Press the POWER/MODE button to turn on the unit, then press the POWER/MODE button
repeatedly until the "BT" indicator appears on the LCD display. It is now ready to pair automatically.
3. Use your mobile phone to search for a Bluetooth device named "MIC200".
4. Your mobile phone will locate"MIC200", and may display connection options. Please connect to it
using the password of "0000" (if any). Once the device is successfully connected, the Bluetooth
indicator "BT connected" appears on the LCD display.
Pairing name: MIC200
Automatically Connecting with Your Phone
Pairing is only needed the first time the unit and phone are used together. Once the unit and phone have been
paired, they will automatically connect whenever the unit is on and Bluetooth is activated on the phone. The
next time you power on, the unit will automatically connect to the most recently connected phone.
Playback from Bluetooth Device
After successful Bluetooth connection, press the PLAY/PAUSE/SCAN button to play. Press the PREV or
NEXT button to skip the tracks backward or forward. To pause or resume playback, press the PLAY/PAUSE/
SCAN button again. Press and hold the PLAY/PAUSE/SCAN button for 2 seconds to disconnect Bluetooth.

Set the Time and Alarm

In Standby Mode
1. Press and hold the MENU/INFO button until 12H or 24H begins to flash.
2. Use the NEXT/PREV button to scroll to '<12H>' or '<24H>'. Press the MENU/INFO button to
confirm.
3. Use the NEXT/PREV button to set the hour and press the MENU/INFO button to confirm.
4. Use the NEXT/PREV button to set the minute and press the MENU/INFO button to confirm
5. Use the NEXT/PREV button to set the hour for the alarm 1 and press the MENU/INFO button to confirm.
6. The minute of alarm 1 will now flash. Use the NEXT/PREV button to scroll to the minutes for the
- EN 6 -