CATOREX UNITS 6565 Bedienungsanleitung Seite 10

4. Operating instructions
Setting the time
Pull out the crown
Set the time by turning the crown in the desired direction.
Push the crown back in completely to position (
perfect synchronization with a time signal.
Setting the date
Set the date* by pressing button
Using the chronograph / Start-Stop function
Timing a single event:
Press button : the chronograph starts.
Press button : the chronograph stops.
Press button
Note: Before you start timing, the hands should be reset to zero. If necessary, press button
Cumulative time function
This measures successive times. Each result is added to the previous one.
Press button : the chronograph starts.
Press button
Repeat these two steps as many times as desired. At the end of the last measurement, the
chronograph displays the total of all the times measured. Press button
completely to position (
. The date changes at each press.
to reset to zero.
again: the chronograph stops.
): the seconds hand stops.
): the seconds hand starts again, allowing
.
to reset to zero.
9