Troubleshooting - 2in1 BASIC Gebrauchsanweisung

Meter does not enter the test mode after inserting a test strip.
Probable cause
The battery is out.
The battery is installed
wrong or there is no
battery.
Test strip inserted upside
down, wrong end in, or
incompletely.
Defective meter or test
strips.
Blood or foreign objects
put into test strip slot.
Test does not start after applying the blood sample.
Probable cause
Blood sample is too
small.
Defective meter or test
strips.
Sample applied when
turn off due to time out
(3 minutes after ready to
test).
36

TROUBLESHOOTING

What to do
Replace the battery.
Check that the battery is installed
correctly. See 33 page.
Insert the test strip with the
printed side up and the electrode
end into the test strip port.
Contact your local distributor.
Contact your local distributor.
What to do
Re-test with a new test strip and
a larger blood sample.
Re-test with a new test strip. If
same problem happens, contact
your local distributor.
Re-test using a new test strip.