Initial Programming - Motostar LIVI series Installationsanleitung

Programming
The kit is pre-configured to manage a single call originating from a single entry panel. One or more receivers answering the same call
can be added, by following the below "Call button programming" procedure.

Initial programming

>3''
<6''
PROG
A
SW3
B
4
5
<1''
PROG
SW3
7
Accessing programming. Press the PROG button A for at least 3 seconds and re-
lease it (within 6 seconds) as soon as the PROG LED comes on and the backlighting on
the buttons flashes as shown in figure B.
Programming button type. Press the first button on the entry panel in the position
marked 3/3A until the backlit LEDS stop flashing 4 and remain lit.
PROG
3
M1
SW3
BOUT
Programming the call keys. Press the door lock release
On the entry panel, press the call key to associate with the internal extension F: an
acoustic signal will confirm that the setting was stored. Hang up the receiver again.
PROG
Repeat the same operations for the other extensions.
SW3
6
Exiting programming. Briefly press the PROG button: the PROG LED goes off.
N.B. If no action is performed, the procedure will automatically end after 30 minutes.
M2
beep
3 A
M1
BOUT
and AUX2 5 buttons.
M2