Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Underbody and cutting device
WARNING!
Wear safety gloves when working on the cutting device and close to it! Use proper
tools to remove debris, e. g. a wooden stick! Never use your bare hands!
Always use original spare parts for replacement. Replace the cutting device only
with an identical component carrying the part number XXXXXX. Do not attach any
other type of cutting device!
The replacement of the cutting device should be done by an experienced user!
Rework or sharpening blades is not recommended unless it is done by a repair
service or a similarly qualified specialist!
1.
Keep the underbody and cutting device clean and free of debris. Remove clippings
from the discharge chute
2.
Check all nuts and bolts periodically for tightness before operation. After prolonged
use, especially in sandy soil conditions, the cutting device will become worn and lose
some of the original shape. The cutting efficiency will be reduced and the cutting
device should be replaced.
3.
Keep the cutting device sharp to ensure a good cutting performance. Replace a worn
or damaged cutting device with a new one of the same type or have it sharpened by
a qualified specialist.
4.
Loosen the bolt (18) anticlockwise using a suitable wrench and remove it together
with cutting device (19) (Fig. 22).
5.
Replace the cutting device with a new one of the same type.
6.
Reattach the cutting device (19) onto the spindle, pay attention to correct alignment.
Tighten the bolt (18) clockwise with 20 Nm max. to ensure safe operation of your
product.
Fig 22
CARE AND MAINTENANCE
18
25
19
Werbung
Kapitel
Inhaltsverzeichnis
