Kawasaki K-AG 2300 Originalbetriebsanleitung Seite 21

• If the use of a guard is recommended for
wire brushing, do not allow any interference
of the wire wheel or brush with the
guard. Wire wheel or brush may expand in
diameter due to work load and centrifugal forces.
Additional safety warnings
Wear safety goggles.
• Use suitable detectors to determine if utility
lines are hidden in the work area or call
the local utility company for assistance.
Contact with electric lines can lead to fire
and electric shock. Damaging a gas line can
lead to explosion. Penetrating a water line
causes property damage or may cause an
electric shock.
• Release the On/Off switch and set it to the
off position when the power supply is
interrupted, e. g., in case of a power failure or
when the mains plug is pulled. This prevents
uncontrolled restarting.
• When working stone, use dust extraction.
The vacuum cleaner must be approved for
the extraction of stone dust. Using this
equipment reduces dust-related hazards.
• Use a cutting guide when cutting stone.
Without sideward guidance, the cutting disc
can jam and cause kickback.
• When working with the machine, always
hold it firmly with both hands and provide
for a secure stance. The power tool is guided
more secure with both hands.
• Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
• Keep your workplace clean. Blends of
materials are particularly dangerous. Dust from
light alloys can burn or explode.
• Never use the machine with a damaged cable.
Do not touch the damaged cable and
pull the mains plug when the cable is damaged
while working. Damaged cables increase
the risk of an electric shock.
21
GB