Secure Delete Of Existing Pairings; Using A Navigation System; Operating Functions When Using A Mobile Phone - AKE Stealth - Bluetooth - Helmset NG Bedienungsanleitung

3. The Bluetooth helmet set stops the alternate flashing red and blue when it is
paired successfully.

Secure delete of existing pairings

If stored pairings that are no longer needed or faulty on the Stealth Bluetooth
Helmet Set NG, it is possible to delete them secure
1. Hold down the multi functional button while switching on pairing
hold down the multi functional button further 10 seconds 10 times flashing
2. P air with the new or with any other phone or navigator
3. Pair new with the intercom partner.

Using a navigation system

The Stealth Bluetooth Helmet Set NG was optimized to be used with
Zumo 660, etc.. Some
our FAQs. After the navigation voice announcements have ended, the intercom will
automatically be connected again in intercom mode.
Operating functions when using a mobile phone or smartphone
Calling tone: Adjust your mobile phone in such a way that the ring tone in the
helmet is heard. For
should not be too short as the start of the signal will be lost when audio is in
stand-by mode.
Accept phone calls: Shortly press the multifunction key once. At many mobile
phones it is possible to activate the automatic call acceptance. This would
reduce the handling to a minimum.
Reject incoming phone calls: Shortly press the multi functional key twice to reject
an incoming phone call.
End phone calls: Shortly press at the multi functional key or just wait until your
calling partner hangs up, the connection will automatically end.
Making phone calls: If you wish to make phone calls, you have to enter the
phone number at your mobile phone or use redialling.
Voice control (not available at all mobile phones): Press the multi function key
approx. 3 sec. to start voice control. At many devices you have to wait for the
confirmation tone, then clearly say the necessary command (refer to the user
manual of the connected device). Samsung Galaxy: Press multi function button
until beep, than release immediately! Wait for the ready signal, than speak.
Redial: Double-click, to call the last dialled number shortly press the multi
functional button twice.
Volume: The volume can be changed on the
26
®
TomTom Urban might have timing problems, please refer to
automatic call acceptance
:
(
(
(important!)
the setting of the ring melodie
Bluetooth helmet set and on the
mode) and
).
®
Garmin , e.g.