General Instructions - Akron 3462 Installations-, Betriebs- Und Wartungsanleitung

WARNING: The Bumper Monitor contains moving parts . Keep hands, fingers and objects away
from pinch points .
WARNING: Not designed for explosive environments .
WARNING: Exceeding the maximum pressure and flow of the Bumper Monitor or nozzle may cause damage .
WARNING: Do not disconnect Bumper Monitor from quick disconnect base while flowing .

GENERAL INSTRUCTIONS

• Review the instructions, wiring diagram, component layout and rotational stops diagram before installing this
unit . This unit operates on 12 or 24 volt DC depending on the unit chosen . All electrical current flows through the
wires . The Bumper Monitor does not act as a ground .
Figure 1
• Not recommended for use in salt water applications.
• For firefighting by trained firefighters only.
• For use with water or standard fire fighting foams only. After use with foam, flush with fresh water.
• Do not use the nozzle as a forcible entry tool.
• Drain the monitor and nozzle after use to prevent "freeze damage".
• Ensure that the thread in the nozzle swivel matches the thread on the Bumper Monitor outlet. Do not
overtighten the nozzle .
• The Bumper Monitor, nozzle, logic box, control boxes and field adjustable rotation stops are made for optimal
performance, Do not alter in any manner .
• Do not install shutoffs on the outlet of the Bumper Monitor.
Side View
Page 02
11-7/16
8-3/8
Top View
1-1/2 NH OUTLET
8-29/32