Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The regulators are designed to operate in a normal non-corrosive indoor environment. They don't
require maintenance. They are installed vertically in places where they are easily accessible for control
and where they properly measure the room temperature, which is at about a height of 150 cm in the
shade, away from drafts and sources of heat and cold (air conditioner outlets, refrigerator, electric
appliances).
the bottom with terminals and the cover with a PCB and control panel. They are attached with 2 or 4
screws on a flush-mounted box with a diameter of 50 mm or on the wall. At the bottom of the box is an
opening for cable. It is recommended to first install the bottom and only insert the cover with the
electronics after the construction works are finished to prevent damage.
When removing the cover with electronics, proceed as follows:
Gently press the sides of the bottom and carefully pull the right side of the cover with a 2 pole
●
connector up by a few millimeters
●
Carefully pull up the left side of the cover with a 7 pole connector
●
Unfasten the cover from the bottom with a vertical movement
Don't pull the cover too much to the side, it could damage the pins in the cover connector!
Clasps are only on the sides of the cover, not at the top and bottom!
18
Werbung
