Mandik UC301 Betriebsanleitung Seite 13

OID is control system for two-stage control of radiant heaters. It consist of switchboard OI and controller
UC301. The switchboard OI is available for one to six heaters, the number of heaters connected is
indicated by the number in the OID type, OID 1 to OID 6.
1 main control switch.
The „I" position centrally turns on the OID control
The „0" position centrally shuts off the OID control
2 three-position switch for each heater
Positions:
● in this case the heater is manually ON,
regardless of the MANDÍK UC301 regulator
- central position In this case the
●
specific heater is manually OFF
● in this case the heater is controlled
automatically by MANDÍK UC301 regulator
3 power indicator light for each heater
4 operating indicator light for each heater
1. Switch the main electrical switch „0 " to the „ I" position.
2. Turn the control switch of individual heaters „
„ " the electric
network green indicator light will light up „
depending on the type of control box - OID 1 to OID 6. OID 1 controls 1 Helios heater, OID 6 controls
6 Helios heaters)
3. After the venting time (about 50 seconds) the infrared heater starts up and the green indicator light
lights
up on the control box „
a red indicator light is on, which turns off when the heater starts up.
4. If the heater does not start up (the green indicator light does not turn on and the red indicator light
remains on after 60 seconds), it is necessary to disconnect and reconnect the heater to a power
supply
(turn the control switch „
infrared heater fails to work after multiple ignition cycles, call your service organization.
5. The performance of two-stage infrared heaters in the case of OID is controlled automatically by the
MANDÍK UC301 regulator.
6. Temperature sensor - the temperature sensor is a standard part of the UC301 regulator. If necessary,
the temperature sensor ASTF Pt 1000 can be connected to the regulator for measuring radiant
temperature. A detailed procedure for changing the sensor can be found below in the regulator manual.
" on the control box. (the number of switches will vary
" and at the bottom of the burner box of the heater. During the venting time,
- STOP - " to the „STOP" position and back to „
13
- STOP - " manually „ " or automatically
" or „ ". If the