HEIDENHAIN ND 1300 Quadra-Chek Installationsanleitung Seite 16

ND 1300 QUADRA-CHEK
Installation Instructions
Operating Instructions available at www.heidenhain.de
Connecting a CNC control cable
This product provides a connection for CNC joystick and amplifier control.
To connect a CNC control cable:
Verify that the power switch is in the off position
X X
Connect the interface cable to it's connector
X X
Tighten the cable connector screws until they are snug
X X
Connecting a coaxial video input
This product provides a coaxial video input for composite video.
To connect a coaxial cable:
Verify that the power switch is in the off position
X X
Connect the interface cable to it's connector
X X
Tighten the cable connector until it is snug
X X
Connecting a Y/C video input
This product provides a Y/C video input for S-video.
To connect a S-video cable:
Verify that the power switch is in the off position
X X
Insert the S-video cable into the Y/C connector
X X
Connecting an encoder
This product can be used with linear and rotary encoders that provide digital TTL level
signals or 1Vpp signals. The connecting cable must not exceed 30 meters in length.
To connect an encoder cable:
Verify that the power switch is in the off position
X X
Connect the interface cable to it's connector
X X
Tighten the cable connector screws until they are snug
X X
Connecting an RS-232-C cable
This product provides an RS-232 connection for PC communication. For more information
on RS-232 communications, refer to the ND 1300 QUADRA-CHEK Operating Instructions.
To connect an RS-232 cable:
Verify that the power switch is in the off position
X X
Connect the interface cable to it's connector
X X
Tighten the cable connector screws until they are snug
X X
16
9
CNC control connector
10
Coaxial connector
11
Y/C connector
13
1 Vpp connector
TTL connector
14
RS-232-C connector