Installation - HEIDENHAIN ND 1300 Quadra-Chek Installationsanleitung

ND 1300 QUADRA-CHEK
Installation Instructions
Operating Instructions available at www.heidenhain.de
The ND 130x can be used as a tabletop unit when placed on the provided stand. The
unit can then be tilted forward or backward by up to 20° for the best reading angle. The
ND 130x is secured to the swivel slots of the stand by a shoulder screw (5), a cap screw
(1) and washers (2, 3 & 4).
To attach the stand:
Attach the unit to the stand as shown at the right
X X
Partially tighten the cap and shoulder screws
X X
Adjust the unit to the desired tilt position
X X
Completely tighten the cap and shoulder screws
X X
Benchtop location and mounting
Rest the unit on a flat, stable surface or bolt the unit to a stable surface from the bottom
using four M5 screws fastened in the pattern shown in "Dimensions" on page 115.

6. Installation

The safety of any system incorporating the use of this product is the
responsibility of the assembler or installer of the system.
Interfaces
Rear
Power switch
3
Replaceable fuse holder
4
Power connector
5
Lighting and zoom input/output
6
connector
Earth (ground) terminal
7
see warning
Remote accessory interface RJ-45
8
for optional foot switch accessory
CNC control outputs for CNC
9
motor amplifier
10 Coaxial video input from NTSC or
PAL cameras
11 Y/C video input from NTSC or PAL
cameras
12 Not used
Notice
Do not engage, or disengage any connections while the unit is under power.
Damage to internal components may result.
Notice
It is necessary to connect the earth (ground) terminal on the rear of the product
to the star point of machine ground. Minimum cross section of the connecting
2
wire: 6 mm . Never use this equipment without proper grounding.
14
Rear (cont)
13 Encoder inputs, X, Y, Z axis for
linear encoders Q axis for rotary
encoder
14 RS-232-C interface for PC
connection. RS-232 cable must not
include crossovers.
15 Not used
16 Optical cable connector for
Comparator reference light source
17 Optical cable connector for
comparator screen sensor
18 Audio out for 3.5 mm
headphone /speaker jack,
monaural, 8 Ohm
19 USB type A interface for printer
or data storage
4
1
2 3
Stand assembly
Power cord
L: Line voltage (brown)
N: Neutral (blue)
Protective conductor (ground)
terminal(green/yellow)
3-conductor (grounded)
Min. cable cross section: 0.75 mm
Max. cable length: 3 m
5
2