Switching Off The Machine; Emergency Stop - Storch Keko 200 Übersetzung Der Original-Anleitung

Switching off the machine

1) Switch off the machine by setting the "ON/OFF" switch to the "OFF (0)" position;
2) Disconnect the power plug from the mains.
3) Disconnect the tool from the air hose.
4) Disconnect the air hose from the air outlet on the compressor.
5) Only drain the condensate from the tank at the end of the working day.
Resettable overload switch
If a current overload and / or short-circuit occurs within the machine's electrical system, the above-mentioned switch is
triggered and it stops the electric motor. To reset the switch proceed as follows:
1.
Set the "ON/OFF" switch to the "OFF (0)" position and have a STORCH service partner determine the cause of the cur-
rent overload / short circuit.
2.
Actuate the push button of the overload switch.
3.
Before restarting the machine wait a few minutes and allow it to cool down.
If the machine doesn't switch on after the reset procedure, it should be checked by a STORCH service partner.

EMERGENCY STOP

The machine can be switched off by setting the "ON/OFF" switch to the "OFF (0)" position.
Switching on after an emergency stop: This should only be attempted after eliminating the cause of the emergency
stop and ensuring the machine is not damaged.
Ongoing maintenance: In order to ensure trouble-free operation the compressor should be subjected to a visual inspec-
tion, examination and, if necessary, a cleaning of the air filter before each use.
Maintenance:
Safety equipment: Make sure all of the equipment is secure and attached properly; conduct a functional test.
Mains cable and plug: Conduct a visual inspection for signs of wear.
Tank: Drain the condensate from the tank at the end of each working day by opening the condensate valve.
Air filter: Remove the screws, remove the cover, remove the filter and clean it with air, reattach the cover properly;
replace the filter if wear is visible.
Any additional maintenance work should be conducted by a STORCH service partner.
Spare parts: Only use original spare parts. Please contact STORCH for these parts.
Translation of the original instruction 48