Electrical Connection - Storch Keko 200 Übersetzung Der Original-Anleitung

Application
Area of application: Stationary in the workshop or on the construction site.
Place of installation: Indoor or outdoor locations (provided that the machine is not subjected to any atmospheric condi-
tions) which are sufficiently illuminated, ventilated and compliant with the occupational safety regulations that are in
effect in the country of use. The machine must be set up on a surface which guarantees its stability with regard to its
weight and overall dimensions.
CAUTION:
Keep children away from the machine.
Intended use: Compression of air (without oil) for the use of applicable pneumatic tools which comply with the corre-
sponding regulations. (e.g.: air atomisation for screw conveyors, hopper guns, compressed air guns, filling, cleaning,
painting processes, etc.).
Assigned operator: An authorised operator who fulfills the occupational requirements.
Restrictions of use: This machine has been designed and produced exclusively for the intended use described and spe-
cified in this manual; in order to ensure the safety of the operator at all times, as well as the efficiency of the machine
itself, any other use is strictly prohibited.

Electrical connection

The machine is connected to the mains supply by inserting the power plug into a suitable socket.
The electric circuit must comply with the applicable regulations that are in force in the country of use, it must fulfil the
relevant technical specifications and it must be properly earthed.
All electrical material used for the connection must be suitable for the respective application and bear the "CE" mark
(provided it is subject to Low Voltage Directive 2006/95/EC), and it must also comply with the regulations that are in
effect in the country of use.
Failure to observe the warnings specified above may result in irreparable damage to the electrical equipment of the
machine and consequently to expiration of the warranty.
The manufacturer does not accept any liability for faults or malfunctions of the machine caused by sudden voltage fluc-
tuations outside the tolerances specified by the distributor (voltage ± 10% - frequency ± 2%).
45 Translation of the original instruction