Safety Precautions - Storch AirClean 4200 PRO Originalanleitung

Safety precautions

The device possesses a voltage range which
can pose an electrical hazard to humans and
animals. It should only be opened and/or disas-
sembled by authorised persons.
Keep away from children:
Do not let children play with or in the vicinity of the device.
Electrical connection:
The extraction fan is designed for use at 230V/50 Hz. Use
an earthed plug! Make sure that the wall sockets being
used are equipped with ground fault circuit interrupters.
Protect the power cable against damage:
Never operate the device with a damaged power cable. If
the power cable is damaged, it must be replaced by a cable
of the same type and rating.
Extension cables:
Use only approved extension cables!
Handle with care:
Do not drop or throw the device as this can cause damage
to its components or wiring.
Using the AirClean extractor fan
The extractor fan is particularly suitable for extracting and
filtering fine airborne dust particles and spray mist to im-
prove the condition of the ambient air during renovation
and restoration procedures, to aid building drying proces-
ses and to aerate and ventilate rooms.
Extraction and filtering of dust and spray mist
The dust bag is mounted at the exhaust side of the extrac-
tor fan to absorb the airborne dust particles and spray mist
generated during renovation and restoration procedures.
The exhaust side is identified by the arrow on the device.
The dust bag is attached to the exhaust side with a clamp.
The dust bag is 3 metres long. It should be ensured that
it is able to fully expand to guarantee optimal filtration of
the dust, dirt and spray mist particles. Optimal extraction
for largescale renovation and restoration procedures can be
achieved if the windows in the room remain closed and the
suction port of the AirClean unit is placed in the entran-
ce door. Seal the door frame above and beside the device
with film. Doing this will generate negative pressure in the
room.
Work on a firm surface:
Always set up the device on a firm and flat surface.
Secure during transport:
When transporting in vehicles, secure the device against
slipping. Never move the appliance while it is switched on.
Keep dry:
Never operate the device in puddles or in water. Do not
store or operate outdoors. If the wiring or any part of the
device becomes wet, dry the device thoroughly before
using. Protect against spray water.
Keep air vents free:
Do not cover or block the air inlets or outlets.
Do not use speed controller:
To reduce the risk of fire or electric shock, never operate
the extraction fan with an electronic speed controller.
Fire hazard: never run the appliance in areas with open
fire or heat sources. Do not use or store the device in area
where vapours, solvents, thinners or petrol are stored.
Using the reusable filter bag (included)
Please make sure the filter bag is cleaned on a regular ba-
sis (shake / wash and dry). A clogged filter will reduce the
suction power of the irRClean unit.
Aeration and ventilation
For aeration and ventilation purposes set up the extraction
fan as required with the outlet side (arrow direction / ven-
tilation), or the inlet side (aeration) on a flat, firm surface
in the open door or open window. The discharged air must
not exceed a temperature of 60° C.
In small rooms place the extraction fan in the door frame
in a way that allows the dust bag to spread out in the ad-
jacent space. Depending on the purpose and room size, it
may be necessary to position the extraction fan properly to
ensure best possible extraction performance.
For example, directly next to the radiator when spray pain-
ting radiators, or in the door frame when sanding ceilings.
27 Translation of the original instruction