Install The Hardware - Axis T91A61 Installationsanleitung

Page 6

Install the Hardware

Install the AXIS T91A61 Wall Mount
Hardware overview,
1. Refer to
parts.
2. Route the network cable through or along the wall.
3. Attach the bracket holder in the desired position using screws that are
appropriate for the wall material and the weight of the camera and
bracket.
4. The wall bracket can temporarily be hooked on the bracket holder, in order to easily route the
cable through the bracket:
Tabs
Slide bracket between the
tabs on the bracket holder
5. Route the necessary cables through the wall bracket, securing them in the cable holder.
6. Pull the locking tab and unhook the wall bracket from the temporary position.
7. Use the Torx screws to secure the wall bracket to the bracket holder.
8. Refer to the Installation Guide for the network camera for instructions on how to attach the
camera to the bracket.
on page 4 for information on the supplied
Swing wall bracket
to the side for
temporary support
Cable
holder
AXIS T91A Series Installation Guide
Cable
Locking tab